/dev/sda: ATA device, with non-removable media Model Number: BHT WR202H0032G E70270F5 Serial Number: -- Firmware Revision: 700100 Transport: Serial, ATA8-AST, SATA 1.0a, SATA II Extensions, SATA Rev 2.5, SATA Rev 2.6 Standards: Used: ATA/ATAPI-7 T13 1532D revision 1 Supported: 9 8 7 6 5 & some of 9 Configuration: Logical max current cylinders 16383 0 heads 16 0 sectors/track 63 0 -- LBA user addressable sectors: 59768832 LBA48 user addressable sectors: 59768832 Logical Sector size: 512 bytes Physical Sector size: 512 bytes Logical Sector-0 offset: 0 bytes device size with M = 1024*1024: 29184 MBytes device size with M = 1000*1000: 30601 MBytes (30 GB) cache/buffer size = unknown Nominal Media Rotation Rate: Solid State Device Capabilities: LBA, IORDY(can be disabled) Standby timer values: spec'd by Vendor, no device specific minimum R/W multiple sector transfer: Max = 1 Current = 1 DMA: sdma2 PIO: pio0 pio1 pio2 pio3 pio4 Cycle time: no flow control=240ns IORDY flow control=120ns Commands/features: Enabled Supported: * SMART feature set Security Mode feature set * Power Management feature set * Write cache Host Protected Area feature set WRITE_BUFFER command * 48-bit Address feature set * Mandatory FLUSH_CACHE * FLUSH_CACHE_EXT * SMART error logging * SMART self-test Media Card Pass Through Command feature set * Gen1 signaling speed (1.5Gb/s) * Gen2 signaling speed (3.0Gb/s) * Host-initiated interface power management Device-initiated interface power management * Software settings preservation * Data Set Management TRIM supported (limit unknown) * Deterministic read data after TRIM Security: Master password revision code = 65534 supported not enabled not locked frozen not expired: security count not supported: enhanced erase 20min for SECURITY ERASE UNIT. Checksum: correct