/dev/sda smartctl 7.4 2023-08-01 r5530 [x86_64-linux-6.10.10-generic-1rosa2023.1-x86_64] (local build) Copyright (C) 2002-23, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Hitachi/HGST Travelstar Z5K500 Device Model: HGST HTS545050A7E380 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: GG2OAC90 User Capacity: 500,107,862,016 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database 7.3/5528 ATA Version is: ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 2.6, 3.0 Gb/s Local Time is: Wed Sep 25 01:17:47 2024 MSK SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 45) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 117) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 062 - 0 2 Throughput_Performance P-S--- 198 198 040 - 132 3 Spin_Up_Time POS--- 214 214 033 - 1 4 Start_Stop_Count -O--C- 099 099 000 - 2643 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate PO-R-- 100 100 067 - 0 8 Seek_Time_Performance P-S--- 112 112 040 - 35 9 Power_On_Hours -O--C- 060 060 000 - 17890 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 099 099 000 - 2616 191 G-Sense_Error_Rate -O-R-- 100 100 000 - 0 192 Power-Off_Retract_Count -O--CK 100 100 000 - 55 193 Load_Cycle_Count -O--C- 001 001 000 - 1128982 194 Temperature_Celsius -O---- 230 230 000 - 26 (Min/Max 8/54) 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0 223 Load_Retry_Count -O-R-- 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 26 Celsius Power Cycle Min/Max Temperature: 23/26 Celsius Lifetime Min/Max Temperature: 8/54 Celsius Specified Max Operating Temperature: 35 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (38) Index Estimated Time Temperature Celsius 39 2024-09-24 23:10 ? - 40 2024-09-24 23:11 29 ********** 41 2024-09-24 23:12 29 ********** 42 2024-09-24 23:13 29 ********** 43 2024-09-24 23:14 ? - 44 2024-09-24 23:15 30 *********** 45 2024-09-24 23:16 31 ************ ... ..( 6 skipped). .. ************ 52 2024-09-24 23:23 31 ************ 53 2024-09-24 23:24 ? - 54 2024-09-24 23:25 32 ************* ... ..( 11 skipped). .. ************* 66 2024-09-24 23:37 32 ************* 67 2024-09-24 23:38 33 ************** ... ..( 24 skipped). .. ************** 92 2024-09-25 00:03 33 ************** 93 2024-09-25 00:04 34 *************** 94 2024-09-25 00:05 34 *************** 95 2024-09-25 00:06 33 ************** ... ..( 2 skipped). .. ************** 98 2024-09-25 00:09 33 ************** 99 2024-09-25 00:10 34 *************** ... ..( 2 skipped). .. *************** 102 2024-09-25 00:13 34 *************** 103 2024-09-25 00:14 33 ************** 104 2024-09-25 00:15 33 ************** 105 2024-09-25 00:16 33 ************** 106 2024-09-25 00:17 34 *************** 107 2024-09-25 00:18 33 ************** 108 2024-09-25 00:19 33 ************** 109 2024-09-25 00:20 ? - 110 2024-09-25 00:21 34 *************** ... ..( 4 skipped). .. *************** 115 2024-09-25 00:26 34 *************** 116 2024-09-25 00:27 33 ************** 117 2024-09-25 00:28 34 *************** ... ..( 35 skipped). .. *************** 25 2024-09-25 01:04 34 *************** 26 2024-09-25 01:05 ? - 27 2024-09-25 01:06 22 *** 28 2024-09-25 01:07 ? - 29 2024-09-25 01:08 23 **** 30 2024-09-25 01:09 23 **** 31 2024-09-25 01:10 24 ***** 32 2024-09-25 01:11 24 ***** 33 2024-09-25 01:12 25 ****** ... ..( 2 skipped). .. ****** 36 2024-09-25 01:15 25 ****** 37 2024-09-25 01:16 26 ******* 38 2024-09-25 01:17 26 ******* SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0009 2 189 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 2 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS