/dev/sda smartctl 7.2 2020-12-30 r5155 [x86_64-linux-6.8.0-50-generic] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Silicon Motion based SSDs Device Model: TS480GSSD220S Serial Number: -- LU WWN Device Id: 5 7c3548 ... Firmware Version: R0327B0 User Capacity: 480,103,981,056 bytes [480 GB] Sector Size: 512 bytes logical/physical Rotation Rate: Solid State Device Form Factor: 2.5 inches TRIM Command: Available, deterministic Device is: In smartctl database [for details use: -P show] ATA Version is: ACS-2 T13/2015-D revision 3 SATA Version is: SATA 3.2, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Fri Dec 27 10:34:16 2024 IST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Unavailable === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 120) seconds. Offline data collection capabilities: (0x11) SMART execute Offline immediate. No Auto Offline data collection support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. No Selective Self-test supported. SMART capabilities: (0x0002) Does not save SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 10) minutes. SMART Attributes Data Structure revision number: 1 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate -O--CK 100 100 050 - 0 5 Reallocated_Sector_Ct -O--CK 100 100 050 - 0 9 Power_On_Hours -O--CK 100 100 050 - 4379 12 Power_Cycle_Count -O--CK 100 100 050 - 1921 160 Uncorrectable_Error_Cnt -O--CK 100 100 050 - 0 161 Valid_Spare_Block_Cnt PO--CK 100 100 050 - 100 163 Initial_Bad_Block_Count -O--CK 100 100 050 - 21 164 Total_Erase_Count -O--CK 100 100 050 - 59432 165 Max_Erase_Count -O--CK 100 100 050 - 211 166 Min_Erase_Count -O--CK 100 100 050 - 22 167 Average_Erase_Count -O--CK 100 100 050 - 123 168 Max_Erase_Count_of_Spec -O--CK 100 100 050 - 1500 169 Remaining_Lifetime_Perc -O--CK 100 100 050 - 92 175 Program_Fail_Count_Chip -O--CK 100 100 050 - 0 176 Erase_Fail_Count_Chip -O--CK 100 100 050 - 0 177 Wear_Leveling_Count -O--CK 100 100 050 - 0 178 Runtime_Invalid_Blk_Cnt -O--CK 100 100 050 - 0 181 Program_Fail_Cnt_Total -O--CK 100 100 050 - 0 182 Erase_Fail_Count_Total -O--CK 100 100 050 - 0 192 Power-Off_Retract_Count -O--CK 100 100 050 - 48 194 Temperature_Celsius -O---K 100 100 050 - 39 195 Hardware_ECC_Recovered -O--CK 100 100 050 - 2597 196 Reallocated_Event_Count -O--CK 100 100 050 - 0 197 Current_Pending_Sector -O--CK 100 100 050 - 0 198 Offline_Uncorrectable -O--CK 100 100 050 - 0 199 UDMA_CRC_Error_Count -O--CK 100 100 050 - 2 232 Available_Reservd_Space -O--CK 100 100 050 - 100 241 Host_Writes_32MiB ----CK 100 100 050 - 207858 242 Host_Reads_32MiB ----CK 100 100 050 - 330070 245 TLC_Writes_32MiB -O--CK 100 100 050 - 311940 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x04 GPL,SL R/O 8 Device Statistics log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x30 GPL,SL R/O 9 IDENTIFY DEVICE data log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xde GPL VS 8 Device vendor specific log SMART Extended Comprehensive Error Log Version: 1 (1 sectors) Device Error Count: 2 CR = Command Register FEATR = Features Register COUNT = Count (was: Sector Count) Register LBA_48 = Upper bytes of LBA High/Mid/Low Registers ] ATA-8 LH = LBA High (was: Cylinder High) Register ] LBA LM = LBA Mid (was: Cylinder Low) Register ] Register LL = LBA Low (was: Sector Number) Register ] DV = Device (was: Device/Head) Register DC = Device Control Register ER = Error register ST = Status register Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 2 [1] occurred at disk power-on lifetime: 0 hours (0 days + 0 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER -- ST COUNT LBA_48 LH LM LL DV DC -- -- -- == -- == == == -- -- -- -- -- 00 -- 00 00 00 00 00 00 00 00 00 00 00 Commands leading to the command that caused the error were: CR FEATR COUNT LBA_48 LH LM LL DV DC Powered_Up_Time Command/Feature_Name -- == -- == -- == == == -- -- -- -- -- --------------- -------------------- b0 00 d0 01 01 00 00 4f 00 c2 00 00 00 00:00:00.000 SMART READ DATA 2f 00 00 01 01 00 00 00 00 00 03 00 00 00:00:00.000 READ LOG EXT 2f 00 00 01 01 00 00 00 00 00 00 00 00 00:00:00.000 READ LOG EXT b0 00 d5 01 01 00 00 4f 00 c2 00 00 00 00:00:00.000 SMART READ LOG b0 00 d8 00 00 00 00 4f 00 c2 00 00 00 00:00:00.000 SMART ENABLE OPERATIONS Error 1 [0] log entry is empty SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 4211 - # 2 Short offline Aborted by host 30% 4209 - # 3 Short offline Completed without error 00% 4208 - # 4 Short offline Completed without error 00% 4151 - # 5 Short offline Completed without error 00% 4135 - # 6 Short offline Completed without error 00% 4118 - # 7 Short offline Completed without error 00% 4035 - # 8 Short offline Completed without error 00% 3991 - # 9 Short offline Completed without error 00% 3957 - #10 Short offline Completed without error 00% 3833 - #11 Short offline Completed without error 00% 3813 - #12 Short offline Completed without error 00% 3721 - #13 Short offline Completed without error 00% 3699 - #14 Short offline Completed without error 00% 3613 - #15 Short offline Completed without error 00% 3546 - #16 Short offline Completed without error 00% 3526 - #17 Short offline Completed without error 00% 3492 - #18 Short offline Interrupted (host reset) 70% 3410 - #19 Short offline Completed without error 00% 3261 - Selective Self-tests/Logging not supported SCT Commands not supported Device Statistics (GP Log 0x04) Page Offset Size Value Flags Description 0x01 ===== = = === == General Statistics (rev 1) == 0x01 0x008 4 1921 --- Lifetime Power-On Resets 0x01 0x010 4 4379 --- Power-on Hours 0x01 0x018 6 737313656 --- Logical Sectors Written 0x01 0x020 6 8365 --- Number of Write Commands 0x01 0x028 6 156664241 --- Logical Sectors Read 0x01 0x030 6 35980 --- Number of Read Commands 0x07 ===== = = === == Solid State Device Statistics (rev 1) == 0x07 0x008 1 8 --- Percentage Used Endurance Indicator |||_ C monitored condition met ||__ D supports DSN |___ N normalized value Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 4 0 Command failed due to ICRC error 0x0002 4 0 R_ERR response for data FIS 0x0005 4 0 R_ERR response for non-data FIS 0x000a 4 3 Device-to-host register FISes sent due to a COMRESET