/dev/sda smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.15.0-52-generic] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Western Digital Caviar Blue Serial ATA Device Model: WDC WD1600AAJS-60WAA0 Serial Number: -- LU WWN Device Id: 5 0014ee ... Firmware Version: 58.01D58 User Capacity: 160,041,885,696 bytes [160 GB] Sector Size: 512 bytes logical/physical Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS (minor revision not indicated) SATA Version is: SATA 2.5, 3.0 Gb/s Local Time is: Sun Nov 13 11:39:14 2022 CET SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM feature is: Unavailable Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 4380) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 55) minutes. SCT capabilities: (0x303f) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-- 200 200 051 - 1 3 Spin_Up_Time PO---- 157 153 021 - 3108 4 Start_Stop_Count -O--CK 090 090 000 - 10534 5 Reallocated_Sector_Ct PO--CK 200 200 140 - 0 7 Seek_Error_Rate POSR-- 200 200 051 - 0 9 Power_On_Hours -O--CK 082 082 000 - 13373 10 Spin_Retry_Count PO--C- 100 100 051 - 0 11 Calibration_Retry_Count PO--C- 100 100 051 - 0 12 Power_Cycle_Count -O--CK 090 090 000 - 10450 184 End-to-End_Error PO--CK 100 100 097 - 0 187 Reported_Uncorrect -O--CK 100 100 000 - 0 188 Command_Timeout -O--CK 100 098 000 - 4295032845 190 Airflow_Temperature_Cel -O---K 065 055 040 - 35 192 Power-Off_Retract_Count -O--CK 197 197 000 - 2848 193 Load_Cycle_Count -O--CK 196 196 000 - 12967 194 Temperature_Celsius -O---K 108 098 000 - 35 196 Reallocated_Event_Count -O--CK 200 200 000 - 0 197 Current_Pending_Sector -O--C- 200 200 000 - 0 198 Offline_Uncorrectable ----C- 200 200 000 - 0 199 UDMA_CRC_Error_Count -OSRCK 200 200 000 - 0 200 Multi_Zone_Error_Rate ---R-- 200 196 051 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 5 Comprehensive SMART error log 0x03 GPL R/O 6 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa0-0xa7 GPL,SL VS 16 Device vendor specific log 0xa8-0xb7 GPL,SL VS 1 Device vendor specific log 0xc0 GPL,SL VS 1 Device vendor specific log 0xc1 GPL VS 12 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (6 sectors) Device Error Count: 1 CR = Command Register FEATR = Features Register COUNT = Count (was: Sector Count) Register LBA_48 = Upper bytes of LBA High/Mid/Low Registers ] ATA-8 LH = LBA High (was: Cylinder High) Register ] LBA LM = LBA Mid (was: Cylinder Low) Register ] Register LL = LBA Low (was: Sector Number) Register ] DV = Device (was: Device/Head) Register DC = Device Control Register ER = Error register ST = Status register Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 1 [0] occurred at disk power-on lifetime: 0 hours (0 days + 0 hours) When the command that caused the error occurred, the device was in an unknown state. After command completion occurred, registers were: ER -- ST COUNT LBA_48 LH LM LL DV DC -- -- -- == -- == == == -- -- -- -- -- 04 -- 00 01 00 00 51 00 00 a7 01 00 00 Commands leading to the command that caused the error were: CR FEATR COUNT LBA_48 LH LM LL DV DC Powered_Up_Time Command/Feature_Name -- == -- == -- == == == -- -- -- -- -- --------------- -------------------- 00 34 ea 09 a6 00 00 00 00 00 00 00 c7 00:00:00.000 NOP [Reserved subcommand] [OBS-ACS-2] 00 08 00 00 c0 09 33 00 a6 35 00 00 00 09:19:14.432 NOP [Abort queued commands] 00 0f 35 09 a3 00 f0 00 f8 00 00 00 00 00:10:32.370 NOP [Reserved subcommand] [OBS-ACS-2] 00 10 00 00 00 09 0a 00 a3 35 00 00 00 00:01:01.446 NOP [Abort queued commands] SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 13316 - # 2 Short offline Completed without error 00% 13300 - # 3 Short offline Completed without error 00% 13233 - # 4 Short captive Completed without error 00% 13204 - # 5 Extended offline Interrupted (host reset) 80% 1 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 2 SCT Version (vendor specific): 258 (0x0102) Device State: Active (0) Current Temperature: 35 Celsius Power Cycle Min/Max Temperature: 34/35 Celsius Lifetime Min/Max Temperature: 34/45 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/85 Celsius Temperature History Size (Index): 128 (3) Index Estimated Time Temperature Celsius 4 2022-11-13 09:32 ? - 5 2022-11-13 09:33 22 *** 6 2022-11-13 09:34 22 *** 7 2022-11-13 09:35 23 **** 8 2022-11-13 09:36 25 ****** 9 2022-11-13 09:37 26 ******* 10 2022-11-13 09:38 27 ******** 11 2022-11-13 09:39 27 ******** 12 2022-11-13 09:40 28 ********* 13 2022-11-13 09:41 29 ********** 14 2022-11-13 09:42 30 *********** 15 2022-11-13 09:43 30 *********** 16 2022-11-13 09:44 30 *********** 17 2022-11-13 09:45 31 ************ 18 2022-11-13 09:46 31 ************ 19 2022-11-13 09:47 32 ************* 20 2022-11-13 09:48 32 ************* 21 2022-11-13 09:49 32 ************* 22 2022-11-13 09:50 33 ************** 23 2022-11-13 09:51 33 ************** 24 2022-11-13 09:52 33 ************** 25 2022-11-13 09:53 34 *************** ... ..( 22 skipped). .. *************** 48 2022-11-13 10:16 34 *************** 49 2022-11-13 10:17 35 **************** ... ..( 36 skipped). .. **************** 86 2022-11-13 10:54 35 **************** 87 2022-11-13 10:55 34 *************** ... ..( 4 skipped). .. *************** 92 2022-11-13 11:00 34 *************** 93 2022-11-13 11:01 35 **************** 94 2022-11-13 11:02 34 *************** 95 2022-11-13 11:03 34 *************** 96 2022-11-13 11:04 ? - 97 2022-11-13 11:05 35 **************** ... ..( 5 skipped). .. **************** 103 2022-11-13 11:11 35 **************** 104 2022-11-13 11:12 34 *************** 105 2022-11-13 11:13 35 **************** ... ..( 2 skipped). .. **************** 108 2022-11-13 11:16 35 **************** 109 2022-11-13 11:17 34 *************** 110 2022-11-13 11:18 34 *************** 111 2022-11-13 11:19 35 **************** ... ..( 8 skipped). .. **************** 120 2022-11-13 11:28 35 **************** 121 2022-11-13 11:29 34 *************** ... ..( 7 skipped). .. *************** 1 2022-11-13 11:37 34 *************** 2 2022-11-13 11:38 35 **************** 3 2022-11-13 11:39 35 **************** SCT Error Recovery Control: Read: 85 (8.5 seconds) Write: 85 (8.5 seconds) Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x000a 2 2 Device-to-host register FISes sent due to a COMRESET 0x8000 4 2096 Vendor specific