/dev/sda === START OF INFORMATION SECTION === Model Family: Hitachi/HGST Travelstar 5K750 Device Model: Hitachi HTS547575A9E384 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: JE4OA60A User Capacity: 750,156,374,016 bytes [750 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 2.6, 3.0 Gb/s Local Time is: Fri May 15 15:22:18 2020 BST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 45) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 201) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 062 - 0 2 Throughput_Performance P-S--- 198 198 040 - 142 3 Spin_Up_Time POS--- 194 194 033 - 1 4 Start_Stop_Count -O--C- 097 097 000 - 5557 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate PO-R-- 100 100 067 - 0 8 Seek_Time_Performance P-S--- 115 115 040 - 34 9 Power_On_Hours -O--C- 046 046 000 - 23923 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 098 098 000 - 3924 191 G-Sense_Error_Rate -O-R-- 100 100 000 - 65536 192 Power-Off_Retract_Count -O--CK 099 099 000 - 353 193 Load_Cycle_Count -O--C- 043 043 000 - 571848 194 Temperature_Celsius -O---- 150 150 000 - 40 (Min/Max 7/56) 196 Reallocated_Event_Count -O--CK 100 100 000 - 70 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0 223 Load_Retry_Count -O-R-- 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 SATA NCQ Queued Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 23802 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) SCT Support Level: 1 Device State: Active (0) Current Temperature: 40 Celsius Power Cycle Min/Max Temperature: 22/40 Celsius Lifetime Min/Max Temperature: 7/56 Celsius Lifetime Average Temperature: 34 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (107) Index Estimated Time Temperature Celsius 108 2020-05-15 13:15 45 ************************** ... ..( 46 skipped). .. ************************** 27 2020-05-15 14:02 45 ************************** 28 2020-05-15 14:03 46 *************************** 29 2020-05-15 14:04 45 ************************** 30 2020-05-15 14:05 45 ************************** 31 2020-05-15 14:06 44 ************************* 32 2020-05-15 14:07 43 ************************ 33 2020-05-15 14:08 42 *********************** 34 2020-05-15 14:09 42 *********************** 35 2020-05-15 14:10 41 ********************** 36 2020-05-15 14:11 41 ********************** 37 2020-05-15 14:12 40 ********************* 38 2020-05-15 14:13 40 ********************* 39 2020-05-15 14:14 40 ********************* 40 2020-05-15 14:15 ? - 41 2020-05-15 14:16 39 ******************** 42 2020-05-15 14:17 39 ******************** 43 2020-05-15 14:18 38 ******************* ... ..( 2 skipped). .. ******************* 46 2020-05-15 14:21 38 ******************* 47 2020-05-15 14:22 39 ******************** 48 2020-05-15 14:23 39 ******************** 49 2020-05-15 14:24 39 ******************** 50 2020-05-15 14:25 38 ******************* 51 2020-05-15 14:26 38 ******************* 52 2020-05-15 14:27 ? - 53 2020-05-15 14:28 22 *** 54 2020-05-15 14:29 23 **** 55 2020-05-15 14:30 23 **** 56 2020-05-15 14:31 23 **** 57 2020-05-15 14:32 24 ***** 58 2020-05-15 14:33 24 ***** 59 2020-05-15 14:34 24 ***** 60 2020-05-15 14:35 25 ****** 61 2020-05-15 14:36 25 ****** 62 2020-05-15 14:37 25 ****** 63 2020-05-15 14:38 26 ******* 64 2020-05-15 14:39 26 ******* 65 2020-05-15 14:40 27 ******** 66 2020-05-15 14:41 29 ********** 67 2020-05-15 14:42 30 *********** 68 2020-05-15 14:43 30 *********** 69 2020-05-15 14:44 31 ************ 70 2020-05-15 14:45 32 ************* 71 2020-05-15 14:46 32 ************* 72 2020-05-15 14:47 33 ************** 73 2020-05-15 14:48 33 ************** 74 2020-05-15 14:49 33 ************** 75 2020-05-15 14:50 34 *************** 76 2020-05-15 14:51 34 *************** 77 2020-05-15 14:52 35 **************** 78 2020-05-15 14:53 35 **************** 79 2020-05-15 14:54 36 ***************** 80 2020-05-15 14:55 36 ***************** 81 2020-05-15 14:56 36 ***************** 82 2020-05-15 14:57 37 ****************** 83 2020-05-15 14:58 37 ****************** 84 2020-05-15 14:59 38 ******************* 85 2020-05-15 15:00 37 ****************** ... ..( 3 skipped). .. ****************** 89 2020-05-15 15:04 37 ****************** 90 2020-05-15 15:05 38 ******************* ... ..( 11 skipped). .. ******************* 102 2020-05-15 15:17 38 ******************* 103 2020-05-15 15:18 39 ******************** ... ..( 2 skipped). .. ******************** 106 2020-05-15 15:21 39 ******************** 107 2020-05-15 15:22 40 ********************* SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0009 2 13 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 10 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS