/dev/nvme0n1 smartctl 7.4 2023-08-01 r5530 [x86_64-linux-6.9.7-arch1-1] (local build) Copyright (C) 2002-23, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Number: APPLE SSD SM0256L Serial Number: -- Firmware Version: CXS7CA0Q PCI Vendor/Subsystem ID: 0x144d IEEE OUI Identifier: 0x002538 Controller ID: 2 NVMe Version: <1.2 Number of Namespaces: 1 Namespace 1 Size/Capacity: 251,000,193,024 [251 GB] Namespace 1 Utilization: 58,934,624,256 [58.9 GB] Namespace 1 Formatted LBA Size: 4096 Namespace 1 IEEE EUI-64: 002538 ... Local Time is: Sun Jul 7 21:50:39 2024 CEST Firmware Updates (0x06): 3 Slots Optional Admin Commands (0x0006): Format Frmw_DL Optional NVM Commands (0x001f): Comp Wr_Unc DS_Mngmt Wr_Zero Sav/Sel_Feat Maximum Data Transfer Size: 256 Pages Supported Power States St Op Max Active Idle RL RT WL WT Ent_Lat Ex_Lat 0 + 6.00W - - 0 0 0 0 5 5 1 - 0.0400W - - 1 1 1 1 210 1200 2 - 0.0050W - - 2 2 2 2 1900 5300 Supported LBA Sizes (NSID 0x1) Id Fmt Data Metadt Rel_Perf 0 + 4096 0 0 === START OF SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED SMART/Health Information (NVMe Log 0x02) Critical Warning: 0x00 Temperature: 43 Celsius Available Spare: 100% Available Spare Threshold: 10% Percentage Used: 20% Data Units Read: 97,943,415 [50.1 TB] Data Units Written: 112,218,539 [57.4 TB] Host Read Commands: 3,016,156,996 Host Write Commands: 3,755,012,232 Controller Busy Time: 10,755 Power Cycles: 30,867 Power On Hours: 4,865 Unsafe Shutdowns: 360 Media and Data Integrity Errors: 0 Error Information Log Entries: 202 Error Information (NVMe Log 0x01, 16 of 64 entries) Num ErrCount SQId CmdId Status PELoc LBA NSID VS Message 0 202 0 0x0008 0x4004 0x000 0 0 - Invalid Field in Command 1 201 0 0x1016 0x4004 0x000 0 0 - Invalid Field in Command 2 200 0 0x100a 0x4004 0x000 0 0 - Invalid Field in Command 3 199 0 0x0018 0x4004 0x000 0 0 - Invalid Field in Command 4 198 0 0x000c 0x4004 0x000 0 0 - Invalid Field in Command 5 197 0 0x0018 0x4004 0x000 0 0 - Invalid Field in Command 6 196 0 0x1005 0x4004 0x000 0 0 - Invalid Field in Command 7 195 0 0x0000 0x4004 0x000 0 0 - Invalid Field in Command 8 194 0 0x1016 0x4004 0x000 0 0 - Invalid Field in Command 9 193 0 0x100a 0x4004 0x000 0 0 - Invalid Field in Command 10 192 0 0x1006 0x4004 0x000 0 0 - Invalid Field in Command 11 191 0 0x0000 0x4004 0x000 0 0 - Invalid Field in Command 12 190 0 0x1002 0x4004 0x000 0 0 - Invalid Field in Command 13 189 0 0x000c 0x4004 0x000 0 0 - Invalid Field in Command 14 188 0 0x100a 0x4004 0x000 0 0 - Invalid Field in Command 15 187 0 0x1002 0x4004 0x000 0 0 - Invalid Field in Command ... (48 entries not read) Self-tests not supported /dev/sda smartctl 7.4 2023-08-01 r5530 [x86_64-linux-6.9.7-arch1-1] (local build) Copyright (C) 2002-23, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Silicon Motion based OEM SSDs Device Model: Netac MobileDataStar Serial Number: -- Firmware Version: T0910A0 User Capacity: 250,059,350,016 bytes [250 GB] Sector Size: 512 bytes logical/physical Rotation Rate: Solid State Device Form Factor: M.2 TRIM Command: Available, deterministic, zeroed Device is: In smartctl database 7.3/5528 ATA Version is: ACS-2 T13/2015-D revision 3 SATA Version is: SATA 3.2, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Sun Jul 7 21:50:39 2024 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Unavailable === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 120) seconds. Offline data collection capabilities: (0x11) SMART execute Offline immediate. No Auto Offline data collection support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. No Selective Self-test supported. SMART capabilities: (0x0002) Does not save SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 10) minutes. SMART Attributes Data Structure revision number: 1 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate -O--CK 100 100 050 - 0 5 Reallocated_Sector_Ct -O--CK 100 100 050 - 0 9 Power_On_Hours -O--CK 100 100 050 - 1753 12 Power_Cycle_Count -O--CK 100 100 050 - 384 160 Uncorrectable_Error_Cnt -O--CK 100 100 050 - 0 161 Valid_Spare_Block_Cnt PO--CK 100 100 050 - 100 163 Initial_Bad_Block_Count -O--CK 100 100 050 - 8 164 Total_Erase_Count -O--CK 100 100 050 - 9037 165 Max_Erase_Count -O--CK 100 100 050 - 22 166 Min_Erase_Count -O--CK 100 100 050 - 13 167 Average_Erase_Count -O--CK 100 100 050 - 18 168 Max_Erase_Count_of_Spec -O--CK 100 100 050 - 7000 169 Remaining_Lifetime_Perc -O--CK 100 100 050 - 100 175 Program_Fail_Count_Chip -O--CK 100 100 050 - 0 176 Erase_Fail_Count_Chip -O--CK 100 100 050 - 0 177 Wear_Leveling_Count -O--CK 100 100 050 - 0 178 Runtime_Invalid_Blk_Cnt -O--CK 100 100 050 - 0 181 Program_Fail_Cnt_Total -O--CK 100 100 050 - 0 182 Erase_Fail_Count_Total -O--CK 100 100 050 - 0 192 Power-Off_Retract_Count -O--CK 100 100 050 - 154 194 Temperature_Celsius -O---K 100 100 050 - 40 195 Hardware_ECC_Recovered -O--CK 100 100 050 - 0 196 Reallocated_Event_Count -O--CK 100 100 050 - 0 197 Current_Pending_Sector -O--CK 100 100 050 - 0 198 Offline_Uncorrectable -O--CK 100 100 050 - 0 199 UDMA_CRC_Error_Count -O--CK 100 100 050 - 0 232 Available_Reservd_Space -O--CK 100 100 050 - 100 241 Host_Writes_32MiB ----CK 100 100 050 - 45125 242 Host_Reads_32MiB ----CK 100 100 050 - 33580 245 TLC_Writes_32MiB -O--CK 100 100 050 - 24570 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x04 GPL,SL R/O 8 Device Statistics log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x30 GPL,SL R/O 9 IDENTIFY DEVICE data log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xde GPL VS 8 Device vendor specific log SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] Selective Self-tests/Logging not supported SCT Commands not supported Device Statistics (GP Log 0x04) Page Offset Size Value Flags Description 0x01 ===== = = === == General Statistics (rev 1) == 0x01 0x008 4 384 --- Lifetime Power-On Resets 0x01 0x010 4 1753 --- Power-on Hours 0x01 0x018 6 2957334438 --- Logical Sectors Written 0x01 0x020 6 247291 --- Number of Write Commands 0x01 0x028 6 2200760337 --- Logical Sectors Read 0x01 0x030 6 186494 --- Number of Read Commands 0x07 ===== = = === == Solid State Device Statistics (rev 1) == 0x07 0x008 1 0 --- Percentage Used Endurance Indicator |||_ C monitored condition met ||__ D supports DSN |___ N normalized value Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 4 0 Command failed due to ICRC error 0x0002 4 0 R_ERR response for data FIS 0x0005 4 0 R_ERR response for non-data FIS 0x000a 4 1 Device-to-host register FISes sent due to a COMRESET