/dev/sda === START OF INFORMATION SECTION === Model Family: Western Digital Scorpio Blue Serial ATA (AF) Device Model: WDC WD7500BPVT-22HXZT3 Serial Number: -- LU WWN Device Id: 5 0014ee ... Firmware Version: 01.01A01 User Capacity: 750 156 374 016 bytes [750 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS (minor revision not indicated) SATA Version is: SATA 2.6, 3.0 Gb/s Local Time is: Sat Sep 10 00:43:30 2016 MSK SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 96 (intermediate level with standby) Rd look-ahead is: Enabled Write cache is: Enabled ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: (15300) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 151) minutes. Conveyance self-test routine recommended polling time: ( 5) minutes. SCT capabilities: (0x7035) SCT Status supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 200 200 051 - 0 3 Spin_Up_Time POS--K 175 173 021 - 2241 4 Start_Stop_Count -O--CK 015 015 000 - 85414 5 Reallocated_Sector_Ct PO--CK 200 200 140 - 0 7 Seek_Error_Rate -OSR-K 200 200 000 - 0 9 Power_On_Hours -O--CK 077 077 000 - 17324 10 Spin_Retry_Count -O--CK 100 100 000 - 0 11 Calibration_Retry_Count -O--CK 100 100 000 - 0 12 Power_Cycle_Count -O--CK 098 098 000 - 2746 191 G-Sense_Error_Rate -O--CK 001 001 000 - 2306 192 Power-Off_Retract_Count -O--CK 200 200 000 - 372 193 Load_Cycle_Count -O--CK 001 001 000 - 1647339 194 Temperature_Celsius -O---K 107 086 000 - 40 196 Reallocated_Event_Count -O--CK 200 200 000 - 0 197 Current_Pending_Sector -O--CK 200 200 000 - 0 198 Offline_Uncorrectable ----CK 200 200 000 - 0 199 UDMA_CRC_Error_Count -O--CK 200 200 000 - 0 200 Multi_Zone_Error_Rate ---R-- 200 200 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 5 Comprehensive SMART error log 0x03 GPL R/O 6 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 SATA NCQ Queued Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa0-0xa7 GPL,SL VS 16 Device vendor specific log 0xa8-0xb7 GPL,SL VS 1 Device vendor specific log 0xbd GPL,SL VS 1 Device vendor specific log 0xc0 GPL,SL VS 1 Device vendor specific log 0xc1 GPL VS 93 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (6 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Extended offline Interrupted (host reset) 90% 17324 - # 2 Short offline Completed without error 00% 1 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 258 (0x0102) SCT Support Level: 1 Device State: Active (0) Current Temperature: 40 Celsius Power Cycle Min/Max Temperature: 40/40 Celsius Lifetime Min/Max Temperature: 0/61 Celsius Under/Over Temperature Limit Count: 0/0 Vendor specific: 01 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -41/85 Celsius Temperature History Size (Index): 128 (31) Index Estimated Time Temperature Celsius 32 2016-09-09 22:36 37 ****************** ... ..( 5 skipped). .. ****************** 38 2016-09-09 22:42 37 ****************** 39 2016-09-09 22:43 38 ******************* 40 2016-09-09 22:44 38 ******************* 41 2016-09-09 22:45 38 ******************* 42 2016-09-09 22:46 ? - 43 2016-09-09 22:47 38 ******************* 44 2016-09-09 22:48 38 ******************* 45 2016-09-09 22:49 37 ****************** ... ..( 14 skipped). .. ****************** 60 2016-09-09 23:04 37 ****************** 61 2016-09-09 23:05 ? - 62 2016-09-09 23:06 37 ****************** ... ..( 2 skipped). .. ****************** 65 2016-09-09 23:09 37 ****************** 66 2016-09-09 23:10 ? - 67 2016-09-09 23:11 37 ****************** ... ..( 7 skipped). .. ****************** 75 2016-09-09 23:19 37 ****************** 76 2016-09-09 23:20 36 ***************** 77 2016-09-09 23:21 37 ****************** ... ..( 6 skipped). .. ****************** 84 2016-09-09 23:28 37 ****************** 85 2016-09-09 23:29 ? - 86 2016-09-09 23:30 37 ****************** 87 2016-09-09 23:31 37 ****************** 88 2016-09-09 23:32 ? - 89 2016-09-09 23:33 37 ****************** 90 2016-09-09 23:34 ? - 91 2016-09-09 23:35 37 ****************** 92 2016-09-09 23:36 37 ****************** 93 2016-09-09 23:37 37 ****************** 94 2016-09-09 23:38 ? - 95 2016-09-09 23:39 37 ****************** 96 2016-09-09 23:40 ? - 97 2016-09-09 23:41 38 ******************* 98 2016-09-09 23:42 ? - 99 2016-09-09 23:43 38 ******************* 100 2016-09-09 23:44 ? - 101 2016-09-09 23:45 38 ******************* 102 2016-09-09 23:46 38 ******************* 103 2016-09-09 23:47 38 ******************* 104 2016-09-09 23:48 ? - 105 2016-09-09 23:49 38 ******************* ... ..( 3 skipped). .. ******************* 109 2016-09-09 23:53 38 ******************* 110 2016-09-09 23:54 39 ******************** ... ..( 7 skipped). .. ******************** 118 2016-09-10 00:02 39 ******************** 119 2016-09-10 00:03 38 ******************* ... ..( 14 skipped). .. ******************* 6 2016-09-10 00:18 38 ******************* 7 2016-09-10 00:19 39 ******************** 8 2016-09-10 00:20 39 ******************** 9 2016-09-10 00:21 39 ******************** 10 2016-09-10 00:22 40 ********************* ... ..( 5 skipped). .. ********************* 16 2016-09-10 00:28 40 ********************* 17 2016-09-10 00:29 ? - 18 2016-09-10 00:30 40 ********************* ... ..( 12 skipped). .. ********************* 31 2016-09-10 00:43 40 ********************* SCT Error Recovery Control command not supported Device Statistics (GP/SMART Log 0x04) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 8 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 3 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x8000 4 891 Vendor specific