/dev/sda smartctl 7.4 2023-08-01 r5530 [x86_64-linux-6.6.2-arch1-1] (local build) Copyright (C) 2002-23, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Hitachi/HGST Travelstar Z5K500 Device Model: Hitachi HTS545050A7E380 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: GG2OA6C0 User Capacity: 500,107,862,016 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database 7.3/5528 ATA Version is: ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 2.6, 3.0 Gb/s Local Time is: Tue Nov 28 10:20:53 2023 CET SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 1 (minimum power consumption with standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 45) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 110) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 062 - 0 2 Throughput_Performance P-S--- 100 100 040 - 0 3 Spin_Up_Time POS--- 253 253 033 - 1 4 Start_Stop_Count -O--C- 088 088 000 - 19433 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate PO-R-- 100 100 067 - 0 8 Seek_Time_Performance P-S--- 100 100 040 - 0 9 Power_On_Hours -O--C- 068 068 000 - 14301 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 099 099 000 - 3068 191 G-Sense_Error_Rate -O-R-- 100 100 000 - 0 192 Power-Off_Retract_Count -O--CK 099 099 000 - 217 193 Load_Cycle_Count -O--C- 065 065 000 - 353531 194 Temperature_Celsius -O---- 193 193 000 - 31 (Min/Max 13/48) 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0 223 Load_Retry_Count -O-R-- 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 11615 - # 2 Short offline Completed without error 00% 11597 - # 3 Short offline Completed without error 00% 11590 - # 4 Short offline Completed without error 00% 11577 - # 5 Short offline Completed without error 00% 11567 - # 6 Short offline Completed without error 00% 11556 - # 7 Short offline Completed without error 00% 11543 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 31 Celsius Power Cycle Min/Max Temperature: 18/36 Celsius Lifetime Min/Max Temperature: 13/48 Celsius Specified Max Operating Temperature: 32 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (65) Index Estimated Time Temperature Celsius 66 2023-11-28 08:13 31 ************ 67 2023-11-28 08:14 31 ************ 68 2023-11-28 08:15 31 ************ 69 2023-11-28 08:16 32 ************* 70 2023-11-28 08:17 31 ************ 71 2023-11-28 08:18 32 ************* 72 2023-11-28 08:19 31 ************ ... ..( 4 skipped). .. ************ 77 2023-11-28 08:24 31 ************ 78 2023-11-28 08:25 32 ************* 79 2023-11-28 08:26 32 ************* 80 2023-11-28 08:27 31 ************ ... ..( 26 skipped). .. ************ 107 2023-11-28 08:54 31 ************ 108 2023-11-28 08:55 32 ************* 109 2023-11-28 08:56 32 ************* 110 2023-11-28 08:57 33 ************** 111 2023-11-28 08:58 33 ************** 112 2023-11-28 08:59 33 ************** 113 2023-11-28 09:00 34 *************** 114 2023-11-28 09:01 34 *************** 115 2023-11-28 09:02 34 *************** 116 2023-11-28 09:03 35 **************** ... ..( 5 skipped). .. **************** 122 2023-11-28 09:09 35 **************** 123 2023-11-28 09:10 36 ***************** 124 2023-11-28 09:11 35 **************** 125 2023-11-28 09:12 36 ***************** ... ..( 7 skipped). .. ***************** 5 2023-11-28 09:20 36 ***************** 6 2023-11-28 09:21 35 **************** ... ..( 6 skipped). .. **************** 13 2023-11-28 09:28 35 **************** 14 2023-11-28 09:29 34 *************** 15 2023-11-28 09:30 34 *************** 16 2023-11-28 09:31 34 *************** 17 2023-11-28 09:32 33 ************** ... ..( 3 skipped). .. ************** 21 2023-11-28 09:36 33 ************** 22 2023-11-28 09:37 32 ************* ... ..( 4 skipped). .. ************* 27 2023-11-28 09:42 32 ************* 28 2023-11-28 09:43 31 ************ ... ..( 8 skipped). .. ************ 37 2023-11-28 09:52 31 ************ 38 2023-11-28 09:53 30 *********** ... ..( 4 skipped). .. *********** 43 2023-11-28 09:58 30 *********** 44 2023-11-28 09:59 31 ************ ... ..( 4 skipped). .. ************ 49 2023-11-28 10:04 31 ************ 50 2023-11-28 10:05 32 ************* ... ..( 4 skipped). .. ************* 55 2023-11-28 10:10 32 ************* 56 2023-11-28 10:11 31 ************ 57 2023-11-28 10:12 32 ************* ... ..( 3 skipped). .. ************* 61 2023-11-28 10:16 32 ************* 62 2023-11-28 10:17 31 ************ ... ..( 2 skipped). .. ************ 65 2023-11-28 10:20 31 ************ SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0009 2 65535+ Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 2 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS