/dev/sda === START OF INFORMATION SECTION === Model Family: Hitachi Travelstar 5K500.B Device Model: Hitachi HTS545025B9A300 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: PB2OC64G User Capacity: 250,059,350,016 bytes [250 GB] Sector Size: 512 bytes logical/physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 2.6, 3.0 Gb/s Local Time is: Tue Mar 7 13:37:13 2023 CET SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Disabled APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x84) Offline data collection activity was suspended by an interrupting command from host. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 645) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 83) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 062 - 0 2 Throughput_Performance P-S--- 100 100 040 - 1313 3 Spin_Up_Time POS--- 206 206 033 - 1 4 Start_Stop_Count -O--C- 100 100 000 - 1492 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate PO-R-- 100 100 067 - 0 8 Seek_Time_Performance P-S--- 100 100 040 - 0 9 Power_On_Hours -O--C- 094 094 000 - 2880 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 100 100 000 - 1484 191 G-Sense_Error_Rate -O-R-- 100 100 000 - 0 192 Power-Off_Retract_Count -O--CK 100 100 000 - 51 193 Load_Cycle_Count -O--C- 090 090 000 - 108558 194 Temperature_Celsius -O---- 203 203 000 - 27 (Min/Max 12/45) 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0 223 Load_Retry_Count -O-R-- 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: SMART Off-line Data Collection executing in background (4) Current Temperature: 27 Celsius Power Cycle Min/Max Temperature: 24/27 Celsius Lifetime Min/Max Temperature: 12/45 Celsius Specified Max Operating Temperature: 32 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 5/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 478 (191) Index Estimated Time Temperature Celsius 192 2023-03-07 05:40 29 ********** ... ..( 46 skipped). .. ********** 239 2023-03-07 06:27 29 ********** 240 2023-03-07 06:28 30 *********** ... ..( 15 skipped). .. *********** 256 2023-03-07 06:44 30 *********** 257 2023-03-07 06:45 31 ************ 258 2023-03-07 06:46 32 ************* 259 2023-03-07 06:47 31 ************ ... ..( 7 skipped). .. ************ 267 2023-03-07 06:55 31 ************ 268 2023-03-07 06:56 30 *********** ... ..( 24 skipped). .. *********** 293 2023-03-07 07:21 30 *********** 294 2023-03-07 07:22 31 ************ 295 2023-03-07 07:23 32 ************* ... ..( 4 skipped). .. ************* 300 2023-03-07 07:28 32 ************* 301 2023-03-07 07:29 31 ************ ... ..( 41 skipped). .. ************ 343 2023-03-07 08:11 31 ************ 344 2023-03-07 08:12 30 *********** 345 2023-03-07 08:13 24 ***** 346 2023-03-07 08:14 24 ***** 347 2023-03-07 08:15 25 ****** ... ..( 3 skipped). .. ****** 351 2023-03-07 08:19 25 ****** 352 2023-03-07 08:20 26 ******* ... ..( 5 skipped). .. ******* 358 2023-03-07 08:26 26 ******* 359 2023-03-07 08:27 27 ******** ... ..( 7 skipped). .. ******** 367 2023-03-07 08:35 27 ******** 368 2023-03-07 08:36 28 ********* ... ..( 13 skipped). .. ********* 382 2023-03-07 08:50 28 ********* 383 2023-03-07 08:51 29 ********** ... ..( 21 skipped). .. ********** 405 2023-03-07 09:13 29 ********** 406 2023-03-07 09:14 20 * 407 2023-03-07 09:15 20 * 408 2023-03-07 09:16 21 ** 409 2023-03-07 09:17 22 *** 410 2023-03-07 09:18 23 **** 411 2023-03-07 09:19 24 ***** 412 2023-03-07 09:20 24 ***** 413 2023-03-07 09:21 24 ***** 414 2023-03-07 09:22 25 ****** 415 2023-03-07 09:23 26 ******* ... ..( 11 skipped). .. ******* 427 2023-03-07 09:35 26 ******* 428 2023-03-07 09:36 27 ******** ... ..( 16 skipped). .. ******** 445 2023-03-07 09:53 27 ******** 446 2023-03-07 09:54 28 ********* ... ..( 27 skipped). .. ********* 474 2023-03-07 10:22 28 ********* 475 2023-03-07 10:23 29 ********** ... ..( 39 skipped). .. ********** 37 2023-03-07 11:03 29 ********** 38 2023-03-07 11:04 30 *********** ... ..(115 skipped). .. *********** 154 2023-03-07 13:00 30 *********** 155 2023-03-07 13:01 31 ************ 156 2023-03-07 13:02 31 ************ 157 2023-03-07 13:03 30 *********** ... ..( 2 skipped). .. *********** 160 2023-03-07 13:06 30 *********** 161 2023-03-07 13:07 31 ************ 162 2023-03-07 13:08 30 *********** 163 2023-03-07 13:09 30 *********** 164 2023-03-07 13:10 31 ************ ... ..( 5 skipped). .. ************ 170 2023-03-07 13:16 31 ************ 171 2023-03-07 13:17 30 *********** ... ..( 3 skipped). .. *********** 175 2023-03-07 13:21 30 *********** 176 2023-03-07 13:22 31 ************ ... ..( 6 skipped). .. ************ 183 2023-03-07 13:29 31 ************ 184 2023-03-07 13:30 24 ***** 185 2023-03-07 13:31 24 ***** 186 2023-03-07 13:32 24 ***** 187 2023-03-07 13:33 25 ****** 188 2023-03-07 13:34 25 ****** 189 2023-03-07 13:35 26 ******* 190 2023-03-07 13:36 27 ******** 191 2023-03-07 13:37 27 ******** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0009 2 6 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 6 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS