/dev/sda smartctl 7.1 2019-12-30 r5022 [x86_64-linux-4.9.155-nrj-desktop-1rosa-x86_64] (local build) Copyright (C) 2002-19, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Western Digital Blue Device Model: WDC WD5000LPCX-00VHAT0 Serial Number: -- LU WWN Device Id: 5 0014ee ... Firmware Version: 01.01A01 User Capacity: 500,107,862,016 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ACS-3 T13/2161-D revision 5 SATA Version is: SATA 3.1, 6.0 Gb/s (current: 3.0 Gb/s) Local Time is: Tue Dec 1 13:48:57 2020 MSK SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 8880) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 103) minutes. Conveyance self-test routine recommended polling time: ( 5) minutes. SCT capabilities: (0x3035) SCT Status supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 200 200 051 - 0 3 Spin_Up_Time POS--K 145 141 021 - 1733 4 Start_Stop_Count -O--CK 097 097 000 - 3949 5 Reallocated_Sector_Ct PO--CK 200 200 140 - 0 7 Seek_Error_Rate -OSR-K 200 200 000 - 0 9 Power_On_Hours -O--CK 087 087 000 - 9767 10 Spin_Retry_Count -O--CK 100 100 000 - 0 11 Calibration_Retry_Count -O--CK 100 100 000 - 0 12 Power_Cycle_Count -O--CK 097 097 000 - 3940 192 Power-Off_Retract_Count -O--CK 200 200 000 - 240 193 Load_Cycle_Count -O--CK 158 158 000 - 127526 194 Temperature_Celsius -O---K 108 088 000 - 35 196 Reallocated_Event_Count -O--CK 200 200 000 - 0 197 Current_Pending_Sector -O--CK 200 200 000 - 0 198 Offline_Uncorrectable ----CK 200 200 000 - 0 199 UDMA_CRC_Error_Count -O--CK 200 200 000 - 0 200 Multi_Zone_Error_Rate ---R-- 200 200 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 5 Comprehensive SMART error log 0x03 GPL R/O 6 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x30 GPL,SL R/O 9 IDENTIFY DEVICE data log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa0-0xa7 GPL,SL VS 16 Device vendor specific log 0xa8-0xb6 GPL,SL VS 1 Device vendor specific log 0xb7 GPL,SL VS 48 Device vendor specific log 0xbd GPL,SL VS 1 Device vendor specific log 0xc0 GPL,SL VS 1 Device vendor specific log 0xc1 GPL VS 93 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (6 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Extended offline Completed without error 00% 9762 - # 2 Extended offline Completed without error 00% 9602 - # 3 Extended offline Completed without error 00% 9530 - # 4 Extended offline Completed without error 00% 9465 - # 5 Extended offline Completed without error 00% 9426 - # 6 Extended offline Completed without error 00% 9257 - # 7 Extended offline Completed without error 00% 9099 - # 8 Extended offline Completed without error 00% 8955 - # 9 Extended offline Completed without error 00% 8915 - #10 Extended offline Completed without error 00% 8847 - #11 Extended offline Completed without error 00% 8616 - #12 Extended offline Completed without error 00% 8373 - #13 Extended offline Completed without error 00% 8333 - #14 Extended offline Completed without error 00% 7979 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 258 (0x0102) Device State: Active (0) Current Temperature: 35 Celsius Power Cycle Min/Max Temperature: 27/35 Celsius Lifetime Min/Max Temperature: 9/55 Celsius Under/Over Temperature Limit Count: 0/0 Vendor specific: 01 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -41/85 Celsius Temperature History Size (Index): 128 (105) Index Estimated Time Temperature Celsius 106 2020-12-01 11:41 40 ********************* ... ..( 60 skipped). .. ********************* 39 2020-12-01 12:42 40 ********************* 40 2020-12-01 12:43 41 ********************** 41 2020-12-01 12:44 ? - 42 2020-12-01 12:45 35 **************** ... ..( 2 skipped). .. **************** 45 2020-12-01 12:48 35 **************** 46 2020-12-01 12:49 36 ***************** 47 2020-12-01 12:50 36 ***************** 48 2020-12-01 12:51 37 ****************** ... ..( 6 skipped). .. ****************** 55 2020-12-01 12:58 37 ****************** 56 2020-12-01 12:59 38 ******************* 57 2020-12-01 13:00 38 ******************* 58 2020-12-01 13:01 38 ******************* 59 2020-12-01 13:02 39 ******************** ... ..( 2 skipped). .. ******************** 62 2020-12-01 13:05 39 ******************** 63 2020-12-01 13:06 40 ********************* ... ..( 10 skipped). .. ********************* 74 2020-12-01 13:17 40 ********************* 75 2020-12-01 13:18 41 ********************** 76 2020-12-01 13:19 ? - 77 2020-12-01 13:20 27 ******** 78 2020-12-01 13:21 28 ********* ... ..( 3 skipped). .. ********* 82 2020-12-01 13:25 28 ********* 83 2020-12-01 13:26 29 ********** 84 2020-12-01 13:27 29 ********** 85 2020-12-01 13:28 29 ********** 86 2020-12-01 13:29 30 *********** 87 2020-12-01 13:30 30 *********** 88 2020-12-01 13:31 31 ************ ... ..( 3 skipped). .. ************ 92 2020-12-01 13:35 31 ************ 93 2020-12-01 13:36 32 ************* 94 2020-12-01 13:37 32 ************* 95 2020-12-01 13:38 32 ************* 96 2020-12-01 13:39 33 ************** ... ..( 3 skipped). .. ************** 100 2020-12-01 13:43 33 ************** 101 2020-12-01 13:44 34 *************** ... ..( 2 skipped). .. *************** 104 2020-12-01 13:47 34 *************** 105 2020-12-01 13:48 35 **************** SCT Error Recovery Control command not supported Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 1 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 1 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x8000 4 1730 Vendor specific