Probe #e1d742770d of ASRock G31M-S Desktop Computer

Log: smartctl

/dev/sda smartctl 7.3 2022-02-28 r5338 [x86_64-linux-6.1.1-desktop-1omv2290] (OpenMandriva Lx 7.3-2) Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Hitachi/HGST Travelstar Z5K500 Device Model: HGST HTS545050A7E380 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: GG2OACY0 User Capacity: 500,107,862,016 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database ATA Version is: ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 2.6, 3.0 Gb/s Local Time is: Wed Jan 25 08:30:00 2023 GMT SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 45) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 112) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 062 - 0 2 Throughput_Performance P-S--- 198 198 040 - 125 3 Spin_Up_Time POS--- 200 200 033 - 1 4 Start_Stop_Count -O--C- 098 098 000 - 4726 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate PO-R-- 095 095 067 - 5 8 Seek_Time_Performance P-S--- 090 090 040 - 54 9 Power_On_Hours -O--C- 086 086 000 - 6370 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 098 098 000 - 3617 191 G-Sense_Error_Rate -O-R-- 100 100 000 - 0 192 Power-Off_Retract_Count -O--CK 100 100 000 - 157 193 Load_Cycle_Count -O--C- 087 087 000 - 133041 194 Temperature_Celsius -O---- 253 253 000 - 15 (Min/Max 8/46) 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0 223 Load_Retry_Count -O-R-- 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 15 Celsius Power Cycle Min/Max Temperature: 10/15 Celsius Lifetime Min/Max Temperature: 8/46 Celsius Specified Max Operating Temperature: 26 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (69) Index Estimated Time Temperature Celsius 70 2023-01-25 06:23 21 ** ... ..( 3 skipped). .. ** 74 2023-01-25 06:27 21 ** 75 2023-01-25 06:28 22 *** 76 2023-01-25 06:29 21 ** 77 2023-01-25 06:30 21 ** 78 2023-01-25 06:31 22 *** 79 2023-01-25 06:32 21 ** ... ..( 70 skipped). .. ** 22 2023-01-25 07:43 21 ** 23 2023-01-25 07:44 20 * 24 2023-01-25 07:45 21 ** ... ..( 2 skipped). .. ** 27 2023-01-25 07:48 21 ** 28 2023-01-25 07:49 20 * 29 2023-01-25 07:50 20 * 30 2023-01-25 07:51 20 * 31 2023-01-25 07:52 21 ** 32 2023-01-25 07:53 20 * 33 2023-01-25 07:54 21 ** ... ..( 4 skipped). .. ** 38 2023-01-25 07:59 21 ** 39 2023-01-25 08:00 20 * 40 2023-01-25 08:01 20 * 41 2023-01-25 08:02 20 * 42 2023-01-25 08:03 21 ** 43 2023-01-25 08:04 20 * 44 2023-01-25 08:05 21 ** 45 2023-01-25 08:06 21 ** 46 2023-01-25 08:07 20 * 47 2023-01-25 08:08 21 ** 48 2023-01-25 08:09 21 ** 49 2023-01-25 08:10 20 * 50 2023-01-25 08:11 20 * 51 2023-01-25 08:12 21 ** ... ..( 3 skipped). .. ** 55 2023-01-25 08:16 21 ** 56 2023-01-25 08:17 20 * ... ..( 3 skipped). .. * 60 2023-01-25 08:21 20 * 61 2023-01-25 08:22 ? - 62 2023-01-25 08:23 10 - 63 2023-01-25 08:24 11 - 64 2023-01-25 08:25 12 - 65 2023-01-25 08:26 12 - 66 2023-01-25 08:27 14 - 67 2023-01-25 08:28 15 - 68 2023-01-25 08:29 15 - 69 2023-01-25 08:30 15 - SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0009 2 0 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 0 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS


Hardware for Linux and BSD

GitHub