/dev/sda === START OF INFORMATION SECTION === Model Family: SAMSUNG SpinPoint P120 Device Model: SAMSUNG SP2514N Serial Number: -- Firmware Version: VF100-50 User Capacity: 250 059 350 016 bytes [250 GB] Sector Size: 512 bytes logical/physical Device is: In smartctl database [for details use: -P show] ATA Version is: ATA/ATAPI-7 T13/1532D revision 4a Local Time is: Sat May 27 15:16:35 2017 EEST ==> WARNING: May need -F samsung3 enabled; see manual for details. SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Disabled APM feature is: Unavailable Rd look-ahead is: Enabled Write cache is: Enabled ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED See vendor-specific Attribute list for marginal Attributes. General SMART Values: Offline data collection status: (0x84) Offline data collection activity was suspended by an interrupting command from host. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 4960) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 82) minutes. SCT capabilities: (0x003f) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-- 100 100 051 - 0 3 Spin_Up_Time POS--- 253 001 025 Past 6144 4 Start_Stop_Count -O--CK 084 084 000 - 16676 5 Reallocated_Sector_Ct PO--CK 253 253 010 - 0 7 Seek_Error_Rate POSR-- 253 253 051 - 0 8 Seek_Time_Performance P-S--K 253 253 015 - 0 9 Power_On_Hours -O--CK 100 100 000 - 16457 10 Spin_Retry_Count PO--CK 253 253 051 - 0 11 Calibration_Retry_Count -O--C- 253 253 000 - 0 12 Power_Cycle_Count -O--CK 092 092 000 - 8720 187 Reported_Uncorrect -O--CK 001 001 000 - 7996935 190 Airflow_Temperature_Cel -O---K 157 091 000 - 27 194 Temperature_Celsius -O---K 157 091 000 - 27 195 Hardware_ECC_Recovered -O-RC- 100 100 000 - 858288 196 Reallocated_Event_Count -O--CK 253 253 000 - 0 197 Current_Pending_Sector -O--C- 253 100 000 - 0 198 Offline_Uncorrectable ----CK 253 253 000 - 0 199 UDMA_CRC_Error_Count -OSRCK 200 200 000 - 0 200 Multi_Zone_Error_Rate -O-R-- 100 100 000 - 0 201 Soft_Read_Error_Rate -O-R-- 253 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 2 Comprehensive SMART error log 0x03 GPL R/O 2 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log SMART Extended Comprehensive Error Log Version: 1 (2 sectors) Invalid Error Log index = 0x0500 (reserved = 0x00) SMART Extended Self-test Log (GP Log 0x07) not supported SMART Self-test log structure revision number 1 No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 0 Note: revision number not 1 implies that no selective self-test has ever been run SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 2 SCT Version (vendor specific): 256 (0x0100) SCT Support Level: 1 Device State: Active (0) Current Temperature: 27 Celsius Power Cycle Max Temperature: 28 Celsius Lifetime Max Temperature: 49 Celsius SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 10/55 Celsius Min/Max Temperature Limit: 5/60 Celsius Temperature History Size (Index): 128 (11) Index Estimated Time Temperature Celsius 12 2017-05-27 13:09 25 ****** 13 2017-05-27 13:10 25 ****** 14 2017-05-27 13:11 26 ******* 15 2017-05-27 13:12 26 ******* 16 2017-05-27 13:13 26 ******* 17 2017-05-27 13:14 27 ******** 18 2017-05-27 13:15 27 ******** 19 2017-05-27 13:16 27 ******** 20 2017-05-27 13:17 28 ********* 21 2017-05-27 13:18 28 ********* 22 2017-05-27 13:19 28 ********* 23 2017-05-27 13:20 29 ********** ... ..( 2 skipped). .. ********** 26 2017-05-27 13:23 29 ********** 27 2017-05-27 13:24 30 *********** ... ..( 3 skipped). .. *********** 31 2017-05-27 13:28 30 *********** 32 2017-05-27 13:29 31 ************ ... ..( 5 skipped). .. ************ 38 2017-05-27 13:35 31 ************ 39 2017-05-27 13:36 32 ************* ... ..( 5 skipped). .. ************* 45 2017-05-27 13:42 32 ************* 46 2017-05-27 13:43 33 ************** ... ..( 10 skipped). .. ************** 57 2017-05-27 13:54 33 ************** 58 2017-05-27 13:55 34 *************** ... ..( 2 skipped). .. *************** 61 2017-05-27 13:58 34 *************** 62 2017-05-27 13:59 36 ***************** ... ..( 9 skipped). .. ***************** 72 2017-05-27 14:09 36 ***************** 73 2017-05-27 14:10 37 ****************** ... ..( 11 skipped). .. ****************** 85 2017-05-27 14:22 37 ****************** 86 2017-05-27 14:23 ? - 87 2017-05-27 14:24 20 * 88 2017-05-27 14:25 21 ** 89 2017-05-27 14:26 22 *** 90 2017-05-27 14:27 22 *** 91 2017-05-27 14:28 23 **** 92 2017-05-27 14:29 24 ***** 93 2017-05-27 14:30 24 ***** 94 2017-05-27 14:31 25 ****** 95 2017-05-27 14:32 25 ****** 96 2017-05-27 14:33 25 ****** 97 2017-05-27 14:34 26 ******* 98 2017-05-27 14:35 26 ******* 99 2017-05-27 14:36 27 ******** 100 2017-05-27 14:37 27 ******** 101 2017-05-27 14:38 27 ******** 102 2017-05-27 14:39 28 ********* 103 2017-05-27 14:40 28 ********* 104 2017-05-27 14:41 28 ********* 105 2017-05-27 14:42 29 ********** ... ..( 2 skipped). .. ********** 108 2017-05-27 14:45 29 ********** 109 2017-05-27 14:46 30 *********** ... ..( 3 skipped). .. *********** 113 2017-05-27 14:50 30 *********** 114 2017-05-27 14:51 31 ************ ... ..( 4 skipped). .. ************ 119 2017-05-27 14:56 31 ************ 120 2017-05-27 14:57 32 ************* ... ..( 4 skipped). .. ************* 125 2017-05-27 15:02 32 ************* 126 2017-05-27 15:03 ? - 127 2017-05-27 15:04 21 ** 0 2017-05-27 15:05 22 *** 1 2017-05-27 15:06 23 **** 2 2017-05-27 15:07 24 ***** 3 2017-05-27 15:08 24 ***** 4 2017-05-27 15:09 25 ****** 5 2017-05-27 15:10 25 ****** 6 2017-05-27 15:11 25 ****** 7 2017-05-27 15:12 26 ******* 8 2017-05-27 15:13 26 ******* 9 2017-05-27 15:14 27 ******** 10 2017-05-27 15:15 27 ******** 11 2017-05-27 15:16 28 ********* SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported SATA Phy Event Counters (GP Log 0x11) not supported